Line marking commonly denotes the several patterns and markings made on the road indicating the direction of movement of traffic and numerous other details that help in smooth movement on the road. They are commonly found along the road or even across the road. Usually, these provide awareness to the commuters or even directions to the driver. This knowledge is tested during the driving test as one needs to be clear about these things before actually driving in the road.

Types of line markings

There are numerous types of markings available. The common types of line marking are explained below.

  • Centre broken white line: They are usually present in the single carriageway roads. The lines help to provide a virtual division between the vehicles travelling in opposite directions. Some roads need to follow this marking properly while in some places where the number of vehicles is less the line may not be present.
  • Lane line: These lines are present in single or dual carriageway roads where the traffic travels in the same direction. The lines are smaller and also the gap between two lines is less.
  • Give way road markings: These triangular lines which are present just before a junction represents triangular give way sign. These provide the drivers visual aid and make them extra cautious. They are also represented by a few broken lines across the carriageway.
  • Stop lines and road markings: These lines are commonly solid, wide, and are accompanied by the word ‘STOP’ written in large letters before the line accompanied by a stop sign. The car should stop here even if the road does not have any traffic and is clear to proceed further.
  • Stop lines at signals: The stop signs just before the signals are solid white lines.
  • Hazard warning line: These lines indicate a bend in the road or if the road is approaching a junction. These lines are longer and have minimal gap between the lines. These signs also indicate the nature of the hazards.
  • Hatched markings: These are diagonal lines surrounded by continuous or solid white lines. These lines separate flow of traffic in opposite directions.
  • Dividing chevron markings: Here traffic travels in the same direction on both the side of the marking. The vehicles should check if it is same before entering this space. These are commonly found in one-way traffic roads where there is a central island or an exit lane leaves the area.
  • Chevron marking with solid lines: The traffic is prohibited to enter these spaces. It is commonly used to divide the space for turnings.
  • Hatched road marks for lane reduction: These lines form continuous boundary that does not allow the vehicles from entering except on emergency.
  • Directional arrow marks: These markings are used to pass the double white lines and the hatched markings.
  • Double white lines: These lines should not be crossed except when one needs to turn into a side road or lane, to avoid stationary vehicles or even overtake cyclist.
  • Cycle boxes or lines: These are made to maintain a safe distance between the cyclist and motorists.

Advantages and disadvantages of the line markings

These are some advantages and disadvantages of the line marking. The common advantages are as follows.

  • These are best signs available on the roads for the drivers.
  • They do not reduce the accessibility of the emergency or large vehicles.
  • Doing the markings on the roads is quite cheap.
     

Some disadvantages could be:

  • These markings can easily be ignored.
  • These markings need to be redone or refreshed at regular intervals since they tend to wear away.
  • Without regular maintenance, they would not be effective.

Hence, it is quite clear that the line marking act as a helping hand for the drivers on the roads. These markings are meant to be obeyed so proper maintenance is required to prevent unfavorable incidents on the roads.

Published by Jack Louis